brand Taidacent

Last updated: 29 Dec 2019, 15:52
One page on our website with products by 'Taidacent':

    The following products are available from 'Taidacent':

    Taidacent FPGA Development Board with Spartan6 XC6SLX Compatible with Arduino

    • The development board is a field programmable gate array (FPGA), which uses FPGA-optimized Spartan6 LX9 and high-performance ATmega32U4 logic. This board has a strong processing power.
    • The ATmega32U4 comes with a USB (DFU) bootloader, which will allow you to install future upgrade firmware without having to purchase a downloader.
    • Once powered, the ATmega32U4 will configure the flash FPGA.
    • After the FPGA configuration is successful, use ATmega32U4 to enter the slave mode. This allows your FPGA design to talk to the microcontroller; it gives you access to the serial port and analog input.
    • Provide technical support, if you have any questions, please feel free to send message to us.
    Taidacent FPGA Development Board with Spartan6 XC6SLX Compatible with Arduino

    Taidacent Non Contact Liquid Level Sensor capacitive Sensor Flow Sensor Level Transmitter Float Switch Water Level Switch high and Low Level Output

    • The intelligent non-contact liquid level sensor uses advanced signal processing technology and high-speed signal processing chip to break through the influence of the wall thickness of the container and realize the true non-contact detection of the liquid level in the closed container.
    • The liquid level sensor (probe) is installed above and below the outer wall of the container to be tested (the high and low positions of the liquid level). The non-metallic container does not need to be opened, and the installation is simple and does not affect the production.
    • The liquid level of various toxic substances, strong acids, strong alkalis and various liquids in the high-pressure closed container can be detected.
    • The liquid to be tested is required to be electrically conductive, the contact surface is non-metal, and the pipe is easy to install and can be widely used.
    • High and low level output: If there is induction, the output is high level; no induction, the output is low level. Specially designed for non-metallic pipe liquid level detection
    Taidacent Non Contact Liquid Level Sensor capacitive Sensor Flow Sensor Level Transmitter Float Switch Water Level Switch high and Low Level Output

    Taidacent 2 Wires 15A 20A 30A 40A 60A Slip Ring Collector Ring Rotary Electrical Contact (30A)

    • The rotating contact surface is gold-gold, and the precious metal contact ensures an extremely long working life;
    • 360° smooth and unlimited rotation fully meets image and data transmission;
    • Complete product range, customized products according to customer needs;
    • Compact structure and smooth operation;
    • Low torque, low noise, wide range of applications, can meet the requirements of various industries, and can be customized according to customer needs.

    Taidacent rangepi RK3399 Development Board orangepi Orange Pie Beyond Raspberry pi

    • Master chip Rockchip RK3399 (28nm HKMG process) CPU 6-Core ARM 64-bit Processor Up to 2.0GHz Based on big.LITTLE size core architecture: Dual Core Cortex-A72 (large core) + Quad Core Cortex-A53 (small core)
    • GPU ARM Mali-T860 MP4 Quad Core GPU Support OpenGL ES1.1/2.0/3.0/3.1, OpenVG1.1, OpenCL, DX11 Supports AFBC (Frame Buffer Compression) RAM 2GB DDR3
    • Memory 16GB high speed eMMC MicroSD (TF) Card Slot miniPCIe connector (compatible with USB and mSATA) mSATA interface wireless network Onboard WiFi module (AP6356S): 2.4GHz/5GHz Dual-band WiFi Supports 802.11a/b/g/n/ac Protocol, 2x2 MIMO Technology Bluetooth 4.1 (BLE enabled)
    • Ethernet 10/100/1000Mbps Ethernet (Realtek RTL8211E) Audio frequency 1 x HDMI or 1 x DP (DispalyPort), audio output 1 x headset for audio input and output 1 x SPDIF digital audio interface for audio output 1 x microphone, onboard audio input 1 x I2S, Supports 8 Channels 1 x MIC array interface
    • camera 1 x MIPI-CSI camera interface (up to 13Mpixel per interface) (OV13850 (13M)) Support USB Camera sensor 1 x Gyroscope + Gravity Accelerometer Gyroscope+G(MPU6500) 1 x Gyroscope Gyroscope(LSM6DS3) 1 x Hall Element HALL Sensor (HAL248TWCL) 1 x Optical Sensor Light Sensor (CM32181) 1 x Electronic Compass (AK09911)

    Taidacent STM32F103RCT6 STM32 Development Board Core Board Minimum System Programming Microcontroller 256K ROM 48K RAM Type-C Interface

    • Main frequency 72M, 256K ROM, 48K RAM
    • 1 reset button, 1 user button, 1 power indicator, 1 user LED, 1 Type-C interface
    • 8M master clock crystal, onboard 32.768Khz RTC crystal
    • Bring up the SWD and Bring all serial port by pin, reserve the RTC battery holder pad, and bring all 45 free IO ports
    • High-power 3.3V regulator IC, the maximum external output current is 500ma
    Taidacent STM32F103RCT6 STM32 Development Board Core Board Minimum System Programming Microcontroller 256K ROM 48K RAM Type-C Interface

    Taidacent 10 Pcs Five Direction Navigation Button Module MCU AVR Game 5D Navigation Joystick Independent Keyboard Switch Push Button Module

    • 1,Name:Five direction navigation button module
    • 2,The number of IO:7
    • 3,Operating voltage:2.0V-9.0V
    • 4,Size:25mmx41mm
    • 5,Operating temperature:-40 Celsius -85 Celsius
    Taidacent 10 Pcs Five Direction Navigation Button Module MCU AVR Game 5D Navigation Joystick Independent Keyboard Switch Push Button Module

    Taidacent Orangepi pc2 H5 A53 Development Board Quad-core 64-bit arm Orange pi Super Raspberry pi

    • Orange Pi PC2 is designed for anyone who loves technology and has creative ideas. It is a very simple, fun and practical development board that you can use to build the world around you. It supports Android 4.4, Ubuntu, Debian and other operating systems.
    • Orange Pi PC2 uses the Allwinner H5, a 6-core high-performance processor with a full-core quad-core A53. It has the smoothest interface operation and gaming experience. It integrates Ethernet, DC power input, video/audio output and other interfaces. It supports HDMI, AVOUT. Video output and other functions.
    • Despite its small size, the design is compact and beautiful. The Orange Pi PC cites a wide range of interfaces including HDMI, Ethernet, USB-Host, USB-OTG, DVP camera and more. It also integrates on-board network, onboard storage, LED indicators, and is compatible with the Raspberry Pi GPIO port, with a unique debug serial port.
    • Memory: 1GB DDR3 (shared with GPU)
      Onboard storage: TF card (up to 64GB) / MMC card slot / 2MB EMMC Flash memory
      Onboard network: 100/1000M Ethernet R.145
    • Video input: camera module with CSI interface
      Audio input: MIC
      Video output: HDMI, CVBS
    Taidacent Orangepi pc2 H5 A53 Development Board Quad-core 64-bit arm Orange pi Super Raspberry pi

    Also see: